Awesome! Was it idling during this time, or playing music? I'm guessing that the tube will have a higher temp ceiling while in use that might...
I have some heavily modified headphones I'd like to take measurements of and I have two desk mics available (link one,, link two) along with many...
Unfortunately I don't have a way to take reliable temperature measurements at the moment, although I'd love to try that as a follow-up at some...
Haha, I didn't realize I was coming across in this way although it makes sense after re-reading my post. I was more curious about the specific...
Actually I find that most of my music pushes down to 30 or even 20Hz just from instruments bleeding downwards (verified using spectrogram). By...
I've often heard people say that tube amps need to warm up before they can reach their full potential, but I'm wondering if anyone has any...
I wonder if you could close some of the exterior vents and then open small holes to tune the mid/sub-bass to your desired balance sort of like...
Since he is adding some pretty beefy resistors I'd be hesitant to say that they might be able to save the 0.33ohm output resistors and maybe with...
I'm not sure if I like the idea of a set of $200 cans that are "almost listenable"... let's hope the M1060 is a completely different beast or else...
Out of curiosity, what sort of tube are you using in the Vali?
I've been using this burr grinder ($10) and this vacuum container ($20) for a while now and found it to be a nice cheap setup. The container is...
I've done most of my soldering work using an Aoyue 937+ ($60). It's digital, heats up quickly (~a minute), and replacement tips are easy to find....
It seems to me that a speaker amp would be cheaper anyway (hell, for $100 you could try building one).
Has anyone here had a listen to these? They are a DD+BA design with detachable cable for ~$30 and I think they have much better highs than any...
Separate names with a comma.