Thank you for the tips! And indeed, the transformer is 2x19V RMS 300 VA (2x7.9 A)! :) I will trade it back and get the 24 V version. I think is...
Thank man! Indeed, I need to start soldering the damn thing. Anyway, I want to place a fuse right on the transformer sec , because that is the...
Hello! I think I have found out what is wrong with this simulation.. There is no Serial Resistance and no Parallel Capacitance for the Voltage...
Hello Priidik, thank you for your answer. The values that I've mentioned are computed by LTSpice... I am also puzzled by those figures. I've...
Hello guys, I'm asking here the same question I've asked on https://www.diyaudio.com/, hoping to get a more clear answer... I'm building this...
Thank you je2a3!
Hello guys, do you happen to know what value the volume pot is? Also, I presume it is wired at the input signal. Thank you, Mihnea
Hello Priidik! Thank you for your advice. I'll most likely end up using one of the kits that get attached directly to the heatsink, like this one:...
Thank you again. I have to fill a lot of gaps here, both in experience and on tools&parts. I'll take it slowly. I'm going to buy the kit, with a...
Thank you guys for your replies. The hardest decision is if it worth going for mono block setup (I know that in theory it does, but it's hard to...
Hello guys, I want to build this amplifier myself , starting with this amplifier board:...
Separate names with a comma.