Comments on Profile Post by lcmusiclover

  1. Ksaurav402
    Ksaurav402
    You will have colorful balls on your table. Are you planning to use it as DAC only or as DAC/Amp?
    Apr 8, 2021
  2. lcmusiclover
    lcmusiclover
    Undecided -- still trying to figure out integrating it to my system. Mostly need to decide how to feed M Scaler. Can feed balanced out to my preamp and on to amps. I'll decide what works best over time.
    Apr 8, 2021
  3. Ksaurav402
    Ksaurav402
    M scalar will connect with the transport that you have and then dual BNC to TT2 or single BNC to your Gungnir with 192khz upsampling
    Apr 8, 2021
  4. Ksaurav402
    Ksaurav402
    Not sure if you have HQplayer but would be interested to know how big is the difference if any.
    Apr 8, 2021
  5. lcmusiclover
    lcmusiclover
    S/PDIF or optical to Gungnir Multibit? Any difference? Stupid question -- all outputs active simultaneously? Couldn't confirm in manual.
    Apr 8, 2021
  6. Ksaurav402
    Ksaurav402
    Not sure about the Mscaler. I have seen it paired with TT2 Or Qutest to get max out of it in dual BNC mode. With Gungnir you can anyways go till 192 KHz max. Connect with RCA SPDIF to Gungnir if BNC are used with TT2
    Apr 8, 2021
    Cryptowolf likes this.
  7. Inoculator
    Inoculator
    I am actually really interested to see what you think of this. My local shop rocks this setup A LOT to feed different setups. Gotta admit it always sounds wonderful, but no baseline for me to compare to.
    Apr 8, 2021
    Cryptowolf likes this.
  8. lcmusiclover
    lcmusiclover
    @Inoculator I was lucky enough to be able to visit the seller and plug my source into the M Scaler opt in and cans into the TT2. Expected 'somewhat better' but very pleasantly surprised. Decided to buy after like 10 minutes.
    Apr 8, 2021
    Inoculator likes this.
  9. lcmusiclover
    lcmusiclover
    @Ksaurav402 definitely dual BNC out to TT2. Just trying to figure out best way to feed other DACs. Course maybe I'll just sell all the others :)
    Apr 8, 2021