I’ve had to readjust the ADS when moving my Classic from place-to-place to get it back to perfect 33.3/45rpm, but I can’t remember it being that...
I'll probably end up picking up a pair eventually. I'm curious how well they will seal with that gimbal mechanism. I've had issues getting a good...
Ditto on the MCP2. I’d throw the Soundsmith Strain Gauge system in there too for excellence since it was the best source I’ve ever heard, but not...
A+ for volume switching effort, but I’m still convinced we were just listening to the same amp the whole time lol
Looks like the voltage starts at 115 and dips to 102 once it settles. I cant remember messing around with the deeper settings before, so might be...
The VPI Classic Signature we used for the comparison @sphinxvc mentioned has the HRX pulley with dual belts and is controlled with the older...
Spyderco Waterway might be worth checking out. Haven’t handled one, but LC200N holds a very keen edge for a moderately long time, will never rust,...
I got a 1210GR with a Nagaoka MP500 a few months ago and echo everything you said. It seems like almost a no-brainer for the sub-2k budget. I...
The 2M Red can sound grainy and compressed, and the rest of the 2M line is on the brighter side so it sounds like it might not be a match for your...
I use BJC for everything (including phono), and have never had one fail after 7+ years. If you’re planning on running MM carts with your 1210...
Good find, might need to pick one of those kits up.
I’m on #3 too... still some wobble but not as bad as before after mixing/matching platters, spindles, and bearings. Seems like most of the issues...
Please tell me you have a DIY Lego turntable design in the works :D
Same on both points. My platter mat is oblong by 3ish mm and my platter has roughly .5mm of wobble.
Separate names with a comma.
