It turned out pretty good. [IMG]
So, who's too stupid to give up on this amp? This guy. Here's a new replacement relay I installed with some creative soldering: [IMG] I had to...
Straight from Flux: Shoot was this a chip amp after all :eek: Ah well, it sounds fantastic after mods. Putting nice caps as close to op amps as...
I doubt this as the op amp was hidden on the bottom of the pcb with plenty of room on top. When this amp was new, being fully discrete was a major...
Thanks for your input as always Beefy. I am so satisfied with the performance of this amp now, that I believe I will leave it well enough alone,...
I just noticed that there are two OP amps on the back of the PCB, they are AD8620. It also looks like you could replace them with Burson V6 vivid...
Over 100 hours of burn in, and the changes are pretty dramatic over stock. Resolution is through the roof. I can now hear that the HD6xx are more...
Well, your post got me to actually order parts and install them. Here it is below: [IMG] After talking with Flux and a year of reading capacitor...
If you have an old pi lying around you can buy a dirt cheap clone pifi spdif hat. I Suspect it will better the wiim. I own a pi2aes, pi2aes 2.0...
Say hello to my Fosi v3 where I replaced the pot with a resistor ladder attenuator due to channel imbalance and made a power button for the side....
Wrong thread please delete
Not yet, but it turns out Flux themselves made a modded out “limited version” you can google. I’ll probably re-cap what they did in mine when I...
In the end I fixed the 3K shout with tubes. When I originally tune'd these headphones I was using the CV4003 input tube, and when I switched back...
That's all we have to work off at the moment, but I am contemplating get a flat plate to measure them myself as well. IMO the difference is quite...
After a little input from another forum it would seem after ear gain 3k might be 2db too much. Anyone have suggestions on how to lower it?
Separate names with a comma.