Firstly I just put the sticker over the dust mesh inside the HD800. Then I got sick of it falling off so I pulled off the mesh carefully as...
I have just trimmed these absorbers to 4.5mm depth and retested using Audacity. Now my 6kHz band is very even with the 5 kHz to my ears and the...
Ok, just spent an hour with my wife and daughter where we listened to test tones 5 kHz, 5.5Khz , 6kHz and 6.5Khz to identify which was the...
Late last night I tried a different type of foam. I took the bungs out of my speakers and in the name of science I cut them up just enough to make...
Another thing to consider is how we are measuring the headphone. Consider a speaker with a port. The speaker does not appear to have more bass...
Thanks Sorrodje, do you mean 14mm ? If so then yes that is the measurement I have used with my formulas. By the way I spent my holiday (Australia...
My last post, I promise! Well I did the maths and I'm wrong. The hole in the absorber is not going to boost the treble but boost the low end. With...
Some more probably wrong thinking but... I was thinking about how my speakers hadn't received much attention recently and then the following hit...
Thanks Sorrodje :) When you take your measurements do you put a microphone at a set distance to the phone or do you use a setup which mimics the...
I did another trial with the paper sticker over the central ring (over the fine dust mesh and no foam or any other mod) and used my wife to help...
Just reading through all the mods and noticed your filter paper mod on the centre of the driver. I did this recently with a light paper sticker on...
Yes but I just did a simple experiment with a paper sticker but have ended up really liking the result. With my HD800 the 6Khz peak always seemed...
No, it's not happening for me for some strange reason, gives me an 'unable to upload'. Still, its a simple paper sticker that only covers the...
Stupid me can't upload a normal jpg to this site so have saved it to my avatar.
Even if you could get a ruler out and measure it I think it would be good enough. I just tried a very simple experiment. I placed a thin paper...
Separate names with a comma.