Nearfields for audiophile listening?

Discussion in 'Speakers' started by sashafuckinggrey, Feb 27, 2016.

  1. ColdsnapBry

    ColdsnapBry Friend

    Pyrate
    Joined:
    Feb 4, 2021
    Likes Received:
    753
    Trophy Points:
    93
    Location:
    US/NZ
    Wow nice, unfortunately they were $750 here in NZ. But I don't realy worry about these things anymore as it's a great place here. Still a bit crazy though!
     
  2. goodvibes

    goodvibes Facebook Friend

    Joined:
    Jun 21, 2017
    Likes Received:
    39
    Trophy Points:
    30
    Location:
    Chicago
    Back midrange finds it's way out the port and why they tend to be better in back as it has less effect on the mids in room. In a small speaker it's more likely tuned to 50 or 60 HZ and will load more in back with proximity. Midbass and midrange still comes out that port. Not just the tuned frequency. Isolate a port sometime and give a listen.
     
    • Agreed, ditto, +1 Agreed, ditto, +1 x 2
    • List
  3. Armaegis

    Armaegis Friend

    Pyrate BWC
    Joined:
    Sep 27, 2015
    Likes Received:
    8,184
    Trophy Points:
    113
    Location:
    Winnipeg
    Ports can also be farty, particularly if they aren't flared. Normally only a problem if you stick your ear up to it which isn't the case for most people (I'm not gonna judge if you do). But a rear port too close to a wall does tend to reflect the fartiness and make it audible from the front if it was there to begin with.
     
  4. goodvibes

    goodvibes Facebook Friend

    Joined:
    Jun 21, 2017
    Likes Received:
    39
    Trophy Points:
    30
    Location:
    Chicago
    Known as Chuffing.
     
  5. Armaegis

    Armaegis Friend

    Pyrate BWC
    Joined:
    Sep 27, 2015
    Likes Received:
    8,184
    Trophy Points:
    113
    Location:
    Winnipeg
    Ah thank you. I was wracking my brain trying to remember the word for that! Much more elegant than "fartiness" :oops:
     
  6. Pharmaboy

    Pharmaboy Friend

    Pyrate
    Joined:
    May 3, 2018
    Likes Received:
    2,718
    Trophy Points:
    113
    Location:
    Goshen, NY
    We're all about elegance in this thread.
     
  7. ColdsnapBry

    ColdsnapBry Friend

    Pyrate
    Joined:
    Feb 4, 2021
    Likes Received:
    753
    Trophy Points:
    93
    Location:
    US/NZ
    Just a question that should be pretty easy to answer for you all, but a new to a headphone listener. I'm not sure what to put on the input sensitivity switch on the JBLs +4 or -10.

    The JBL manual says:


    I'm using a Schiit Midgaard, here is the impedance info, I'm using Balanced out:

     
    Last edited: Apr 11, 2024
  8. Pharmaboy

    Pharmaboy Friend

    Pyrate
    Joined:
    May 3, 2018
    Likes Received:
    2,718
    Trophy Points:
    113
    Location:
    Goshen, NY
    Start with -10 dB, just as the instructions suggest. Unless your digital front end is a pro studio board of some kind, -10 dB is correct.

    I had a pair of powered speakers that gave me this option, but the manual was helpfully specific that the +4 dB setting only applied to all-balanced studio gear chains.
     
    • Agreed, ditto, +1 Agreed, ditto, +1 x 1
    • List
  9. ColdsnapBry

    ColdsnapBry Friend

    Pyrate
    Joined:
    Feb 4, 2021
    Likes Received:
    753
    Trophy Points:
    93
    Location:
    US/NZ
    Cool, thanks. I'm guessing it's on -10 from the start? It is fairly loud. I'm at about 9am on my Midgaard volumes pot even on low gain and it sounds like a good 70 - 90 db from where I'm sitting.
     
    • Agreed, ditto, +1 Agreed, ditto, +1 x 1
    • List
  10. Pharmaboy

    Pharmaboy Friend

    Pyrate
    Joined:
    May 3, 2018
    Likes Received:
    2,718
    Trophy Points:
    113
    Location:
    Goshen, NY
    Quite apart from this pro/level vs consumer level thing, gain mismatches can arise in pretty any system, often because the output voltage of the DAC (or streamer) is on the high side.

    For years, the typical output voltage of a single-ended DAC was around 2.0v. Even when the DAC is balanced and has at least 4v output on the 2 x 3-pin XLR outputs of the DAC, the single-ended output via RCA outputs was usually around 2.0v.

    But in recent years, I've seen something of a "gain war" break out, with single-ended DAC outputs commonly being 2.5v or even 3.0v; and balanced outputs of a balanced DAC can go as high as 6-7v. This can cause havoc in one's system.

    My favorite of my 3 NOS DACs, the single-ended MHDT Labs Orchid, is a case in point. Its 3.0v output causes gain issues throughout my complex main system (which supported both headphone amps, preamp, power amp, speakers and sub).

    I'm not really sure what your system is. But if you're connecting pretty much any balanced DAC to a headphone amp, the possibility of excess gain at the amp's output is real.

    PS: the other variables that really matter are the impedance and sensitivity of the headphone in question. If you have a low impedance, very sensitive headphone, any gain issues in the gear that feed it will be even more apparent than would be the case with a high impedance dynamic, or a relatively insensitive planar headphone.
     
    • Like Like x 3
    • Agreed, ditto, +1 Agreed, ditto, +1 x 1
    • List
  11. Armaegis

    Armaegis Friend

    Pyrate BWC
    Joined:
    Sep 27, 2015
    Likes Received:
    8,184
    Trophy Points:
    113
    Location:
    Winnipeg
    Line level matching isn't terribly critical for home use unless you're chaining a whole bunch of devices together. Flip the switches and doohickeys until you get to a useable range on your volume pot and call it a day.
     
    • Like Like x 1
    • Agreed, ditto, +1 Agreed, ditto, +1 x 1
    • List
  12. Thad E Ginathom

    Thad E Ginathom Friend

    Pyrate
    Joined:
    Sep 27, 2015
    Likes Received:
    14,870
    Trophy Points:
    113
    Location:
    India
    For years, I worked on the basis that if you needed +4, you knew you did, and I used it when I had a DAC that had balanced "pro" output.
    Yep. Those years, I guess.
    Gosh. Things got complicated.

    If I remember correctly, the +4 and -10 are not even the same sort of dB. So it not a difference of 14dB. Correct me, someone?
     
    • Agreed, ditto, +1 Agreed, ditto, +1 x 1
    • List
  13. bixby

    bixby Friend

    Pyrate
    Joined:
    Sep 26, 2015
    Likes Received:
    4,135
    Trophy Points:
    113
    Location:
    Northern Colorado
    fwiw The line level out with variable volume on my ifi zen is, I believe, a low 1V, but when I press the power match button I get a much better gain structure for how I use my JBL 305s.

    Like @armgaegis suggests, try a few settings and use your ears to guide you as to what sounds best. For me, the powermatch on add a bit more body along with the increased gain even when volume matched .
     
  14. ColdsnapBry

    ColdsnapBry Friend

    Pyrate
    Joined:
    Feb 4, 2021
    Likes Received:
    753
    Trophy Points:
    93
    Location:
    US/NZ
    Well, was a fun weekend doing some work from my desk and listening to music. But I think I've ultimately decided these studio monitors are not for me. Sound is excellent, but like I figured the low level hiss just drives me crazy. I really like a silent ambient room and I build silent PCs because even a fan noise bugs me. I think I'll try these in my kitchen with some type of Bluetooth capabilities connected.
     
  15. Thad E Ginathom

    Thad E Ginathom Friend

    Pyrate
    Joined:
    Sep 27, 2015
    Likes Received:
    14,870
    Trophy Points:
    113
    Location:
    India
    Sorry, I've lost the plot. Are you talking about the JBLs?
     
  16. ColdsnapBry

    ColdsnapBry Friend

    Pyrate
    Joined:
    Feb 4, 2021
    Likes Received:
    753
    Trophy Points:
    93
    Location:
    US/NZ
    Ah yea JBL 305.
     
  17. Entropy

    Entropy Facebook Friend

    Joined:
    Dec 3, 2022
    Likes Received:
    205
    Trophy Points:
    33
    Location:
    Portland OR
    Yeah that's a slightly unfortunate part about the 305ps. There should be other similar models out there (e.g hs5, lp6v2, A5v) with lower noise.
     
  18. ColdsnapBry

    ColdsnapBry Friend

    Pyrate
    Joined:
    Feb 4, 2021
    Likes Received:
    753
    Trophy Points:
    93
    Location:
    US/NZ
    Yea, I can imagine for 95%+ of people they probably don't even notice the hiss. It's low level, but I'm use to dead silent equipment.
     
  19. bixby

    bixby Friend

    Pyrate
    Joined:
    Sep 26, 2015
    Likes Received:
    4,135
    Trophy Points:
    113
    Location:
    Northern Colorado
    Never noticed it before, but I can hear it with ear about 2-3 inches from tweeter, but nothing a few feet away. I hear my refrigerator in the open kitchen about 20 ft away more than the speakers. Sorry it did not work out for you. Can you return them?
     
  20. ColdsnapBry

    ColdsnapBry Friend

    Pyrate
    Joined:
    Feb 4, 2021
    Likes Received:
    753
    Trophy Points:
    93
    Location:
    US/NZ
    I think at close near field they would be audible, something like arms reach distance, like at my desk. Nah, unfortunately you can't really return a product here in NZ because you don't like them / buyers remorse. There has to be a fault. I can put them up for sale locally with $100 off and they should move fast.
     

Share This Page